Episode 81 - Kitchen Table Finish, Two Table Saws!?, Underrated Tools? & MUCH More!

Support us on Patreon: https://www.patreon.com/woodshoplife   Sean 1) My question is a little out of the ordinary and is about the mental side of woodworking. I have a fast paced, high pressure job that requires a lot of my time. That being said it has allowed me the luxury of jumping into the hobby with both feet and get some really good tools right off the bat. Probably a bad idea what what the hell. Lol. The down side of the job is it limits my time in the shop and also makes it hard to transition into the mindset for woodworking. I have to multitask and move quickly at work, traits that don’t lend themselves well to the hobby. Do you guys ever have trouble slowing/calming down when you are in the shop?  And if so how do you combat this.Thanks, Brian Wilson. 2) I was surprised to hear Guy say he wasn’t a fan of parallel clamps (and instead preferred pipe clamps due to their clamping pressure). They seem to be standard issue for every woodworker I see. Can I ask you all to share any other overrated (or underrated) woodworking tools? Danny   Huy 1) Hello, I have upgraded my table saw to a 3HP Powermatic 66 and was looking at building an outfeed table but seeing wood prices lately,  I am just going to use my old 1 1/2 HP contractor as the "outfeed" table with both saws pushed back to back making sure the miter slots don't interfere with each other. I'm trying to decide on what blades to get for the 2 saws. I see the work you guys do, so I was wondering which blades you would keep installed. Both saws have router tables, so any dado would be done with a router bit. Thanks for all the great podcast, I have been listening since #1- keep up the great work! Travis 2) Hey guys, thanks for putting out such a great podcast! I have been binge listening to the older shows and have heard several discussions on dust collection. Most of them have been focused on connection a large  hose to a smaller dust port and not getting the full performance from this collection. I don’t have a dust collector, just a DeWalt shop vac. Would you saw that some dust collection is better than no dust collection at all? Working on getting a bandsaw that has a 4 inch port, used green (not the newer blue paint job) Rikon 10-315 12” deluxe, and dust collector would be the next purchase after that. Do you think it would be fine to at least use the shop vac to help, or is this a waste of time? Tim Preach   Guy 1) Hello guys and Guy.  Wondering if you could give any recommendations for a table saw blades.  I purchased the Forrest WW2 10" 40T blade back in May, however it is on backorder until November.  Is there another blade you recommend that would be easier to find and use for the time being?  I'm currently running the SawStop PCS 3 hp and just have the standard SawStop blade that came with the saw. Thanks, Paul 2) Hi guys. For a walnut kitchen table, would you use conversion varnish or Arm-r-seal? I can spray if need be. - Ken