Episode 54 - Belt Sanders?,Outfitting A Shop, Storing Lumber In A Shed, & MUCH More!

Support us on Patreon: https://www.patreon.com/woodshoplife   Guy 1) I’m writing about a project where we are making a table and using white oak for the first time. While most boards looked great throughout the milling process, we found that a few board exposed a lot of very small short cracks or voids along the “rays”. I’ve seen this a lot working with heart pine which i have epoxied. How common is this and how do you deal with. Thanks, Mike @ Sibley Manor Woodworks 2) Greetings, love the show. How do each of you feel about hand held belt sanders? (3"X 21" for example). Some fine woodworkers swear by them for projects such as table tops, while others won't even touch them for the hatred of the uneven marks they can leave behind, and relegate them to rough construction only. From my experience I'm in the latter category, although I admit I may not be using the machine properly/correct technique. Are there any special tips or 'insider' knowledge on how to avoid the dips/valleys they leave behind? Or should I go ahead and list my belt sander on Craigslist and be done with it? MLBETT Wood Works Sean 1)Hey Guy(s), Your podcast is great. Thanks for all the help. I am in the process of building a detached garage. Part of it is going to be a shop area. It’s not going to be a big shop area by any means (15’x25’).  I’m planning on making some cabinets and furniture for our future house (kitchen cabinets, vanities, tables, bar area).  Currently, I borrow other friends and family members equipment when doing project due to my limited space in town.  My question is, what equipment do you recommend for my shop?  I realize you need more information so I’ll explain what I have and a budget. I’m looking to spend around $2000-$2,500.  I don’t have many tools but here is what I have - 10” compound sliding miter saw from Harbor Freight that cuts a little off, cordless drills, circular saw with clamp edge guide, jig saw, and a 1/4” trim router.  These tools got me by for small projects but I think it’s time to upgrade.   Thanks for the help! Casey 2) Hey guys I love the podcast and what you’re doing to help the woodworking community. About two years ago I finished my walnut dinning room table. It was my first major project in years since my high school shop days. I learned a lot doing it. But as always made mistakes. I made my table using breadboard ends and I used third coast craftsman’s video as inspiration for the construction of my breadboard ends. After I assembled my table I noticed small gaps between my top and breadboard ends. I was wondering if you could think of any ideas to fix those gaps.  I appreciate the time. Thanks guys. - Trent   Huy 1) Hey guys - I am in the process of building a shed (my new workshop). It's going to be 12x16. I will have full 8ft walls and a 7x5 steel rollup door (like the ones you see at storage units) and it will be insulated however most likely not climate controlled 24/7. My main question is about lumber storage.  since it won't be climate controlled 24/7 should  I be storing lumber in the shop or think about storing it elsewhere. Typically I will only have on hand what I need for the current project or 2.  Any suggestions on maximizing storage in this small space? John 2) I recently bought some CA glue and activator, as I was reading the label it said that it needed to be kept in a cool place and even suggested storing it in the fridge.  Then I remembered that I heard that PVA glue can go bad if left in a place that is to hot.  Where do you guys store your adhesives? -Rick