Episode 42 - How Much Glue Should I Use, Sliding Table Saw, Applying Shellac, & MUCH More!

Support us on Patreon: https://www.patreon.com/woodshoplife Guy's Questions 1: I am making a table top that is 7feet long and I needed to joint the edge of the boards. I have a 6 inch jointer and the total bed length is 46 inches long. After jointing the edge of the boards and placing them next to each other I noticed that some of the jointed edges were concave over the 7 feet and the concave was much too large for a spring joint. To solve for this problem I put the boards together (face to face) then using my #6 flattens the sides. Although this worked, I would have preferred that the joints were not concave off of the jointer. Do you think the concave boards was caused by my technique or is my jointer just too small. If it’s the jointer, what size jointer would have eliminated this problem. I know an aircraft carrier would take care of the problem, but given I am a hobbies and have a budget what would you recommend? Mike 2:I would like to hear your thoughts on sliding table saws vs traditional cabinet saws and if any of you have experience with one. Most online posts (in the US) consider these saws as industrial and/or for production shops working with sheet goods only and not for making furniture.  I have been comparing the PM2000B and the Hammer K3 Winner. I'm aware there is a huge price difference between the two saws $3400 vs $5800 and that a slider needs more floor space to accommodate the outrigger. Neither of them is a Saw Stop so I will probably die shortly after cutting my first board #YOLO In short, if you had the money and space would this be a saw you would consider? Oscar   Sean's Questions 1: Hey guys! I have a question regarding dust collection. Ever since I started getting serious about it, it feels like a never ending spiral for the quest of a "dust-free" shop. Is such a thing possible? Where is the line that you mark as "good enough"? Do you have a daily clean up routine that helps with this? My shop is an attached two car garage, and my wife would love for me to stop dragging sawdust into the house! Thanks guys, love the show and keep up the great content! Antoine 2: I have been practicing with shellac on shop furniture. I have been using premixed off the shelf stuff. I am not getting a smooth finish. I have used both a cloth and a foam brush.  I am thinking that it is the wrong viscosity and I would be better off mixing my own. Can you talk about how you mix shellac? Rick   Huy's Questions 1: I have a 3hp 15" planer. The question is when should I be concerned about changing the gearbox oil and other deep maintenance (besides waxing and blade changes)? I just purchased a Grizzly knockoff that was manufactured in 2003 and never plugged in. I've ran about a hundred board feet through it so far. Besides some rust, it runs perfectly. I think it needs new belts, but wondered if I should go deeper with the maintenance? Thanks, Dave with Matter of Fractions 2: How much glue should you use on glue ups? I typically put too much I think and have a lot of squeeze out. I worry about a strong joint though. What amount is strong enough? A light film of glue, a little puddling, or flooded? Thanks Matt