Episode 16 - Track Saws, Extension Wing Router Table, 3 Festool Picks, and MUCH More!

Support us on Patreon: https://www.patreon.com/woodshoplife Guys Questions: 1) My question for the guys. With the internet providing information and inspiration for projects, do you still subscribe to woodworking magazines?Eric (Poplar_shop) 2) Love the podcast guys. Got a question for the podcast. If you only get 3 Festool tools to that you could have in your shop what would they be? The domino can’t be included in your 3 tools. I have a track saw and looking into a sander possibly the rotex 125. I’m not sure I could justify the price of the kapex though I see you guys all have one.Chris   Seans Questions: 1) This may be too basic to address on the shoe but you all talk of different benches. Assembly, work, and out-feed. I get what an out-feed bench is but what is the difference between work and assembly bench. Rick 2) Can you guys talk tack saws in a future episode? I’ve got some large panels to cut for a coffee bar i’m building and need some feedback on different brands. - W B Designs   Huys Questions: 1) I have a question about a stand-alone router table vs table saw extension wing router table. I’ve recently purchased a 3.25HP router and lift, and I’m now ready to build a dedicated router table. My workspace is a 20’x20’ garage that I share with the family van. Space is limited and everything has to be mobile. My vision has always been to add an extension wing router table to my cabinet saw. My recent concern is keeping the table flat over time. I’ll incorporate a torsion top, but I fear the saw will get too heavy to move around. Do you think I’ll have long term success with the extension wing or should go with a stand alone router table? I look forward to the input, keep up the good work! Thanks Jacob from North Carolina 2) Hi Guys, I love the show. I don’t have any woodworking buddies, so I love the Q&A format because you answer a lot of questions I have as a newish woodworker. I’ve been looking at building a new workbench and like any good woodworker, I’m doing too much research and not enough building. My question is about work holding. What types of vices do you guys prefer, why, what are the pros and cons. I was specifically debating between the Veritas twin screw or a Benchcrafted leg vice and could add a Moxon vice down the line if needed. Do you have any thoughts on either of these? I have a pretty small shop so I do mostly hand tool work since I don’t have much room for machines.Thanks! Matt   Our Instagram picks: Huy: @McintyrefurnitureSean: @gregoryraiewskiGuy: @Woodreview